AWR

Results

-
AWR
AWR

HD Quiz powered by harmonic design

#1. Airborne weather radar system use a wavelength of approximately 3 cm in order to:

#2. The ISO-ECHO facility of an airborne weather radar is provided in order to:

#3. In the MAPPING MODE the airborne weather radar utilises a:

#4. Which of the following cloud types is most readily detected by airborne weather radar when using the weather beam?

#5. In which mode of operation does the aircraft weather radar use a cosecant radiation pattern?

#6. In an Airborne Weather Radar that has a colour cathode ray tube (CRT) the areas of greatest turbulence are indicated on the screen by:

#7. Which of the following is a complete list of airborne weather radar antenna stabilisation axes?

#8. In an Airborne Weather Radar that has a colour cathode ray tube (CRT) increasing severity of rain and turbulence is generally shown by a change of colour from:

#9. A frequency of 10 GHz is considered to be the optimum for use in airborne weather radar system because:

#10. In general the operation of airborne weather radar equipment on the ground is:

#11. The pencil shaped beam of an airborne weather radar is used in preference to the mapping mode for the determination of ground features:

#12. A frequency of airborne weather radar is:

#13. A weather radar, set to the 100 NM scale, shows a squall at 50 NM. By changing the scale to 50 NM, the return on the radar screen should:

#14. In weather radar the use of a cosecant beam in 'Mapping' mode enables:

#15. In Airborne Weather Radar (AWR), the main factors which determine whether a cloud will be detected are:

#16. In Airborne Weather Radar (AWR), the main factors which determine whether a cloud will be detected are:

#17. In order to ascertain whether a cloud return on an Aircraft Weather Radar (AWR) is at or above the height of the aircraft, the tilt control should be set to? (Assume a beam width of 5°)

#18. When switching on the weather radar, after start-up, a single very bright line appears on the screen. This means that the?

#19. Which of the following lists phenomena that CANNOT be detected by weather radar?

#20. The "gain" control knob of an AWR adjusts?

#21. Airborne Weather Radars are generally based on the use of?

#22. In the MAPPING MODE the airborne weather radar utilises a?

#23. In Airborne Weather Radar (AWR) the main factors that determine whether or not a cloud will be detected are?

#24. In order to ascertain whether a cloud return on an Aircraft Weather Radar (AWR) is at or above the height of the aircraft, the tilt control should be set to (assume a beam width of 5 degrees)?

#25. In an Airborne Weather Radar the areas of greatest turbulence are usually indicated on the screen by?

#26. To improve the detection of precipitation area(s) in e.g. Thunderstorms, in which the top of the cloud lies at or slightly above the level of flight?

#27. Which statements relating to the stabilization system of airborne weather radar antennae is true?

#28. Airborne Weather Radar has been primarily developed to detect?

#29. The antennae of modern airborne weather radars are stabilized by means of?

#30. The heaviest turbulence is likely t be encountered?

#31. When using airborne weather radar in the mapping mode in polar areas one runs the risk?

#32. The pictures in the diagram are showing an aircraft's position with respect to some thunderstorm cells and the image the pilot is getting from the radar. To detect this "blind alley" the pilot should?

#33. Is is possible for weather radar to be operated on the ground?

#34. In which frequency band do most Airborne Weather radars operate?

#35. The theoretical maximum range for an airborne weather radar is determined by the?

#36. On the airborne weather radar display in WX mode, different colours use used?

#37. Ground checks of AWR are?

#38. The airborne weather radar (AWR) cannot detect?

#39. Which of the following list of phenomena are least likely to be detect by airborne weather radar?

#40. While using the AWR in the weather mode, the strongest returns on the screen indicates?

#41. On a colour airborne weather radar, a bright red echo indicates?

#42. The ISO-ECHO feature of an airborne weather radar can be used to detect?

#43. On the AWR display the most severe turbulence will be shown?

#44. Airborne weather radar uses a particularly high frequency radar signal, at 9 to 12 GHz, in order to?

#45. An airborne weather radar unit transmits a 5 degrees beam from a parabolic dish aerial reflector assembly. If the wavelength is 4 cm, the diameter of the dish is?

#46. An airborne weather radar unit transmits a 4 degrees beam from a parabolic dish aerial reflector assembly. If the wavelength is 3 cm, the diameter of the dish is?

#47. An airborne weather radar, with a beam width of 4 degrees in azimuth, is being used in the mapping mode. At what maximum range will it be able to detect a 1 nm wide opening in a sea cliff?

#48. The tilt angle on the AWR at which an active cloud just disappears from the screen is 4 degrees up. If the beam width is 5 degrees and the range to the cloud is 40 nm use the 1 in 60 rule to calculate the approximate height of the cloud relative to the aircraft?

#49. An aircraft flying at 25 00 feet is equipped with AWR. The beam width is 5 degrees. With the radar tilted 3.5 degrees up, the radar is showing top of a cloud return at 105 nm. The approximate height of the cloud is.

#50. In an AWR with a 5 degrees beam width how do you orient the scanner to receive returns from clouds that are at or below your level?

#51. The airborne weather radar is using a 5 degree beam. The cloud is detected at a range of 60 nm. If the scanner is tilted up to 5 degrees, the cloud disappears. Using trigonometry to determine the height of the tops of the cloud, in relation to the aeroplanes cruising level, select the nearest answer from the following?

#52. An airborne weather radar is using a 3 degrees beam. A cloud is detected at a range of 40 nm, If the scanner is tilted up to 3 degrees the cloud disappears. The top of the cloud, in relation to the aeroplane's cruising level is approximately?

#53. What frequency is typical chosen for AWR systems?

#54. The AWR can be used on the ground provided: 1. The aircraft is clear of personnel, buildings and vehicles. 2. The conical beam is selected. 3. Maximum up tilt is selected. 4. The AWR must never be operated on the ground.

#55. The cosecant squared beam is used for mapping in the AWR because?

#56. On a weather radar, the greatest turbulence is likely in an area where targets are?

#57. Weather radar is used by the pilot to assist in the?

#58. The stabilisation of the weather radar aerial is effective?

#59. On an AWR the sequence of colours indicating increasing water droplet size is?

#60. The colours used on a conventional AWR to indicate increasing intensity of returns are?

#61. A height ring is used?

#62. A side lobe from an aerial of a weather radar may produce an echo on the screen known as a "height ring". The pilot can use this?

#63. The main factors, which affect whether an AWR will detect a cloud, are?

#64. The ISO-ECHO circuit is incorporated in the AWR?

#65. When the airborne weather radar is operating in its primary mode, to detect precipitation?

#66. Airborne weather radars use a frequency of approximately 9 GHz because?

#67. When using the AWR to detect long range ground features the most suitable mode of operation or beam selected would be?

#68. Using the airborne weather radar, before take-off?

#69. If the AWR transmitter is to be switched on before take-off the scanner should be tilted up with?

#70. AWR in the __________ Mode progressively _________ As distances ___________ To equalise screen brightness?

#71. The airborne weather radar uses the following wavelength?

#72. Before commencing a flight the weather radar should?

#73. The use of AWR on the ground is?

#74. In an AWR with a colour CRT areas of greater turbulence are indicated by?

#75. AWR contour mode is used for?

Finish
AWR
Scroll to top